Tankless water heaters are becoming more and more popular in households across the globe. Not only do they save space, but they are also more energy efficient than traditional tank heaters. And when it comes to a Marey tankless water heater, you can rest assured that you will enjoy a top-quality product.
Marey tankless water heaters work by heating water on demand rather than storing it in a tank. This means that you'll never have to worry about running out of hot water, and you'll also save money on your energy bill.
At Marey, we demonstrate our dedication to quality, safety, and support in everything we do. We make it simple to select the best tankless water heater to support a more fulfilling lifestyle for you and your family. If you're considering switching to a Marey tankless water heater, this blog post will explain how you can install one in your home.
How do You Install a Marey Tankless Water Heater?
- Turn off the circuit breaker to ensure that the electric cables are not powered on while you work. Also, turn the water supply off to prevent flooding.
- If you already have a tank-type water heater in your home, drain it before discarding it. This will entail using a hose and a container, such as a bucket.
- Carefully remove the front cover with a screwdriver. Once all of the screws have been removed, store them in a safe place. All of these screws are required for your water heater to function properly. Remember that cables may be connected between the cover and the unit. Unplug these carefully before removing the cover completely.
- Mount the unit onto the wall. Ensure your water heater is in a clean and tidy area of your home so you can easily access the unit in an emergency.
- Connect the pipes that supply hot water to your home. These connections will go into and out of your water heater. They should be near the bottom of the unit.
- Install the pressure and flow valves. They allow you to turn off the water supply to the heater rather than the entire house when repairs are required.
- Open every hot water outlet for a few minutes to remove any air from the system.
- Examine your Marey tankless water heater's electrical connections. Check that these connections are properly wired and connected to the correct terminals. The cover should then be reattached using all of the previous screws.
- Switch the circuit breaker on. Afterwards, you'll want to configure the system's temperature settings. These units can get very hot when set to the maximum settings, so it's best not to use them to avoid burns. At this point, you should test every hot water outlet in your home, including faucets, showers, dishwashers, and clothes washers, to ensure that the temperature is correct and that the water warms up quickly. If the water is too hot, you should lower the temperature settings.
What are Some of the Most Common Problems with Tankless Water Heaters?
The typical problems people run into when installing tankless water heaters include the following:- Not enough hot water
- Water leaks
- Not enough pressure
- Noisy water heater
- Water tastes bad